The Solar Cover Saddle allows you to remove and store your solar pool cover in minutes. You can also place your solar cover back on the pool while you are in the pool or out. The Solar Saddle is very easy to use, install and is much more affordable than a lot of solar reels being sold.
General directions! The long and short of mounting the accessory is to evenly space out the five holders, and allow 2 1/2 to 3 feet for the cover to extend over/past the outside holders. A Solar Saddle Unit comes with 5 holders and required mounting hardware. Once you get started you should be able to complete the project in 20 to 30 minutes, or less, it's really quite easy. That time will be returned to you several times over. If you are in a real hurry, a cover can be put on or taken off and stored in 2 to 3 minutes, by one person! I used to spend a lot more time than that, and when the cover was off, it always seemed to be in the way. Our prototype was designed on a 24 foot round pool and only used four holders, adding the fifth really completed the system.
Easy On, Easy Off! To remove and store your cover, you simply pull the cover off the pool side and it lays in the holders, folded accordion style. Use is like pulling sheets off the end of your bed. Now your cover is stored.. To put the cover on, just reverse the process. This can be done while you are in the pool, reach over the pool side grasp the cover and back up, or from outside the pool by starting the leading end over the pool edge, grasp the cover and walk along the pool side pulling the cover on as you go. Always use a protective cover to extend the life of your solar cover!
Please Click on any picture below to Enlarge
Last Updated: 04/11/2013 06:20 PM - ID:384